Blog ·
OBS Multistream Bandwidth: a Worked Example
Calculate local upload and relay outbound transfer from OBS bitrate, output count and stream duration without hiding overhead.
Before a multistream, you need two different numbers: the upload leaving your computer and the outbound transfer generated by all active destinations. A single speed test does not answer both questions.
A worked example
Assume OBS sends a 6 Mbps encoded source and three destinations are active for two hours. Ignore audio and protocol overhead for the first pass.
Local outputs: three copies leave the computer. The estimated video upload is 6 Mbps × 3 = 18 Mbps. That is a sustained rate, not a peak to reach once in a speed test. If the connection varies, leave meaningful headroom above it.
Relay source: OBS sends one 6 Mbps stream to the relay. The relay then sends three copies. The source upload stays near one stream, but the relay still pays for each output.
Relay transfer: decimal gigabytes per hour are approximately 0.45 × bitrate in Mbps × output count. Here, 0.45 × 6 × 3 × 2 hours = 16.2 GB of outbound video transfer over the session. One output would be about 5.4 GB for two hours.
The 0.45 factor comes from 3,600 seconds per hour divided by 8 bits per byte and 1,000 megabytes per decimal gigabyte. It is an estimate, not a billing guarantee. Audio, container and protocol overhead, reconnects, variable bitrate and the number of outputs actually live all change the result.
Which number should you plan around?
For local outputs, compare the required sustained upload with a measured stable upload that leaves room for everything else on the connection. If a destination fails, its local connection may stop using bandwidth, but do not treat that as a plan for normal operation.
For a relay, check both sides: your connection must reliably deliver the OBS source, and your plan must allow enough relay hours and outbound transfer. Each additional active output increases relay transfer, even though it does not multiply the source upload. RelayHalo forwards the encoded source without transcoding, so lowering one destination's bitrate independently is not part of this workflow.
Put your real values into the OBS multistream bandwidth calculator, then follow the one-upload setup guide. Run the first connection against a private or unlisted platform event.
Planning for the moment the connection drops matters as much as the average: how to fix OBS disconnects and keep viewers.